Does the blade have multiple notches to allow adjustment as you sharpen it? Are you using the notch that makes the blade shortest?

Yes, thanks! I have clamped one piece to guide my router before, but using two would be much easier since it eliminates the need to measure the offset to the “far” stop every time. Clever!

Can you elaborate on this a bit?

https://ibuildit.ca/projects/wooden-vise/ Cool!

Thanks. Interesting point that even a small bolt is going to be plenty strong for work-holding. So maybe just some all thread of appropriate length? I guess the problem there is the pitch is fine, so it would move very slowly.

Out of curiosity, when do you care about the jaw being flush with the workbench top?

My quick and dirty math based on some captions of the figures from the paper suggest it’s unlikely they’re getting amplification for now, because it seems like the even the “low” resistance state is quite resistive. But I still suspect it can be done, and they do characterize their structures as “active” - thanks!

Well, a logic gate doesn’t fundamentally have to amplify… if the control current exceeds the output, it isn’t amplifying but fill performs logic. I am too lazy to look myself, but did they demonstrate amplification? If not, I think it’s doable.

Couldn’t you build an amplifier by using a thin wire that heats up a larger wire? If you size the large wire to minimize self heating, then a small current would cause the thin wire to act as a heater, switching the large current.

Thanks!

Thank you. On the 1/8 table saw blade, your concern is that you prefer narrower, lighter blades?

Do you have any particular recommendations for identifying quality router bits?

For what it’s worth, it’s the same with Prusa. The only work I do on my printer is glue stick on the PEI sheet when printing otherwise-incompatible materials.

It was sold in the gift shop, not on display. I know it’s not an enormous difference, but let’s try our best to keep the misinformation just on their side.